Clik here to view.
IRMimic™ Trainable IR Remote Control Transmitter using pic microcontoller
IRMimic features: Simple to train – Can learn up to 16 IR commands, and each can be in a different format/protocol Two different operating modes – Keypad or MCU interface LED indicator output –...
View ArticleClik here to view.
Infrared Remote Control with Microcontroller
This little project will demonstrate how you can use NEC IR protocol based TV, DVD or VCR remote control to control you home appliances like fan bulb or virtually anything. There are lots of projects...
View ArticleClik here to view.
RC5 remote control using PIC12F629
All remote controlled projects from this site can be controlled with remote controls which use the RC5 protocol, like the TV-remotes from Philips. When all buttons from such a remote are in use then...
View ArticleClik here to view.
6 CHANNEL RF REMOTE CONTROLLER USING CC2500 RF MODULES
The 6 Channel RF Remote Controller designed using CC2500 RF Transceiver modules and PIC16F1847 micro-controller from microchip. Transmitter provided with 6 tact switch, 4 Address Jumpers to pair...
View ArticleClik here to view.
IR RF TRANSCEIVER CIRCUITS 8 CHANNEL REMOTE CONTROL
IR and RF transceiver circuits PIC16F628 microcontroller based on the software assembly prepared by the donor of the above değşiklik without just sittin ‘with IR or RF controls can be made 8-channel...
View ArticleClik here to view.
IR Remote Control Repeater using PIC12F629
This circuit receives the signal from a IR remote control, like those used to control your TV or DVD player and allows the signal to be repeated in another location. To get a 40Khz carrier requires...
View ArticleClik here to view.
WIRELESS REMOTE CONTROL for Raymarine ST4000 Autopilot using PIC16F628
I had designed a remote unit for my ST4000+ autopilot. It did prove out the concept and I used it a lot, but it sported an unsightly coil cord (and of course unsightly coil cords have no place on...
View ArticleClik here to view.
NEC Protocol IR (Infrared) Remote Control With a Microcontroller
Introduction This little project will demonstrate how you can build NEC protocol based Infrared Remote Control to use with various NEC Protocol IR receivers. actually there are lots of projects out...
View ArticleClik here to view.
Remote-Control Light Dimmer using pic microcontroller
The lamp in my bedroom is a very cheap lamp from Wal-Mart. It stands in one corner of my room, opposite of the door. This is where the problem is: If it is dark, I have to walk across the room, not...
View ArticleClik here to view.
DIY remote control based on PIC16F628
Control up to 8 devices by this easy constructable remote control. It can work as a radio or infrared remote control, depending on the components. Each device output can be configured to be momentary...
View Article